There are two distinct levels of bauxites on the Miltônia-3 plateau located at the Bauxite Province of Paragominas-PA. These levels are separated by a pseudopsolitic to concretionary ferruginous laterite (FL) horizon, marking a hiatus between two distinct cycles of the current bauxite profile formation. The bauxites of the upper level (2nd cycle of formation) have nodular to concrete characteristics whereas those of the basal level (1st cycle of formation) are composed by a more physically complete concrete bauxite (CB) added by another level of a more friable bauxite with clayey portions for its base (concrete bauxite with clayey bauxite - CBCB). It was noticeable the CNB located at the upper level of gibbsite-enriched horizon with low reactive silica and iron contents, which are very similar to those found on the horizon of the main bauxite ore (CB) of the profile. In field observations, on the survey fronts and in the drill holes it was found that this CNB is a gradation of the above Nodular Bauxite (NB) horizon. This gradation is observed by the increase in the size of the bauxite nodules, where their Fe-gibbsite pseudopsolites grows up by coalescence, decreasing the diffused iron and silica contents marked by the change in color from lilac-yellow to a red-orange color, to ocher, in higher depths. It is also noticeable a decrease until the complete disappearance of the Al-ferruginous pseudopsolites, in addition to the decrease of the volume of gibsytic-kaolinite clay at this level. Based on this study using macroscopic and microscopic petrography, SEM/EDS, XRD and chemical analysis, as well as Principal Component Analysis (PCA) and descriptive statistics, two evolution model proposals were developed on the genesis of the upper level of nodular bauxites of this lateritic-bauxite deposit, considering: Model (1) - Origin from the degradation of the original bauxites (1st Cycle), related to a 2nd Lateritization Cycle which consists of the preexistence of mature bauxite (CB), overlapped by FL, which was covered by "Belterra Clay". This new nodular level (NB) occurs through the coalescence process whereby the residual aluminous phase junction occurred, resulting from the migration of Fe and Si in solution out of this level and by the migration of the neighboring levels above the clayey overburden (CAP) and below that of FL and CB, forming and concentrating large scale gibbsitepreferably and secondarily to kaolinite. With the continuous evolution of this level of NB, a maturation of the basal portion of this level is observed, forming the CNB whose nodules are interincreased, connecting locally, consuming neighboring levels above NB and levels below FL and CB, up to the total consumption of these; Model (2) - Its origin from a 2nd Lateritization Cycle, however from a later sedimentary deposition on the lateritic profile of the 1st Cycle. With the exposure of a source rock as a granitoid pluton (Cantão, Japiim, Jonasa, Ourém and Ney Peixoto of Neoproterozoic granites), gneiss (Archaean crystalline basement) or siliciclastic sediments (Itapecuru and Ipixuna Formations of the Upper Cretaceous), whose weathering degradation made it possible the generation of sediments of clayey nature preferentially kaolinite during the Paleogene until the beginning of the Oligocene. Migration of Fe, Si, Ca, Na, etc. occurred outside this level, preserving and concentrating the Al and O in situ, in addition to the residual Si. The process of coalescence allowed for the addition of the residual aluminous phase, preferentially concentrating the gibbsite and secondarily kaolinite, closing the first cycle of bauxite formation. Thereafter, there was a regional upwelling, followed by erosive processes that allowed for the exposure of this previously formed bauxite profile, under a seasonal climate, with an abundance of meteoric water and intense intercalated insolation, where the FL developed, of regional occurrence marking a hiatus between the formation cycles of these bauxites. New regional retraction movement, which allowed for the deposition of sediments of siliciclastic origin, which served as source rock for a new bauxite formation cycle during the Upper Miocene. They may be the same rocks from which physical and chemical degradation provided sediments for the 1st cycle of bauxite formation. Repeating the coalescence process of the residual aluminous phase, with the large scale development preferably of the gibbsite and secondarily kaolinite, closing the second cycle of NB and CNB formation.
|
